One more machine, with the same people
Nel Lecchese
These two machines work and produce without any additional personnel being hired. Operators who follow the machining centres have quickly learned how to operate them. Not only that, the working hours of E.cut are 24/7. Twenty-four hours a day, including Saturdays and Sundays. At an hourly cost that does not exceed three euros, including depreciation! When then in the technical office have understood what you can ‘do’, they began to redesign many details.
And one was not enough anymore!
Stainless steel fittings and parts for the food industry. Mechanical processing, moulding, and construction of its own moulds. It was enough to see it, feel how much it cost, how much is the cost of operation, and above all, the simplicity and ease of use to decide to buy it. To do what? “We don’t know, but a machine like this is always needed in the workshop”, and then, no person to hire.
In Mantua
Maintenance and regeneration of machines for socks. A myriad of metal parts, to be rebuilt. Gears, racks, small and complex cams, notches and cross-references. In the most disparate materials, with treatments and hardnesses that create a lot of problems to the mechanical working through tools. And always in limited quantities. With E.cut from the drawing with CAD to the realization of the piece is a matter of a few minutes. High precision at a very low cost!
In the Cuneo area
Young company. Mechanical equipment and moulds for sheet metal. Conventional wire erosion “didn’t fit”. And not only for a problem of space, but especially for a question of costs. And above all operating costs! At a similar price they could have purchased a conventional used wire erosion, but on the cost of operation of an E.cut, more than ten times lower, they focused their attention. Young people, but with proven experience in mechanical processing, it was enough to see the machine in work and perform some details to discover the reasons, and guess the great potential. One is there, but the place is for two!
